• Scraparatus™
• Sassy Shapes Pinky Dinky Die Set
• "Mother" stickers of your choice
• Cardstock in your choice of color, 10" x 6" (scored in half)
• Cardstock in another color of your choice, 2 ¼” x 4 5/8”
• Cardstock in a third color of your choice, 1 small scrap
• Cardstock in a fourth color of your choice, 3 3/8” x 1” and 1" scrap
• Adhesive
• Dimensional Tape
• 1 red 1/8” eyelet
• 4 lime green 1/8” eyelets
• Black permanent pen

Instructions:

1. Trim cardstock to 10” x 6”. Fold in half to make a 5” x 6” card.
   
2. Using heart and flower dies from Sassy Shapes Pinky Dinky Die Set and Scraparatus, die cut four hearts from 2 ¼” x 4 5/8” cardstock (another color) as shown, then die cut two hearts from different colored card stock.
   
3. Adhere cardstock to left side of card as shown.
   
4. Adhere 3 3/8” x 1” piece of cardstock to lower right side of card.
   
5. Adhere “If mothers were flowers I’d pick you” sticker (or other Mother sticker of your choice) to upper portion of card, as shown. Use dimensional tape if desired.
   
6. Using Scraparatus with small hole punch tip, punch a hole in each of the die-cut hearts. Set a lime eyelet in each hole using Scraparatus and 1/8” eyelet splitter or rounder tip.
   
7. Using Scraparatus with small hole punch tip, punch a hole in the center of the flower die-cut. Set red eyelet in hole using Scraparatus and 1/8” eyelet splitter or rounder tip.
   
8. Using dimensional tape or adhesive foam squares, adhere hearts to card in the shape of a butterfly as shown. Also adhere flower as shown.
   
9. Using a permanent black pen, draw butterfly head, antennae and dot trail from flower.